SCAR Talon Ambi 45_90 Safety Selector
Please read all instructions thoroughly before and during install to gain a complete understanding of the parts and process.
The OEM FN Scar Talon selector detent and spring are reused! The larger detent and spring (if) provided in packaging is for an AR15 and not needed.
Be smart! Remove all ammo from your workspace to avoid being a statistic.
Tools:
Small flathead screwdriver
| Paperclip or provided tool
| Patience | FN Scar Talon
Dificulty: 4/10
0. Start by gaining access to the SCAR Talon trigger housing by removing the lower receiver. With the hammer forward, remove the OEM safety selector by using a small flat head screwdriver to remove the set screws in the side of the OEM levers and gently pull off the levers. Remove the center shaft from the right towards the left side of the receiver. The selector detent and spring will remain in the lower receiver.
1. Install the desired size safety lever onto the left side of the center shaft by inserting the spring then small detent into the center shaft and then sliding the lever onto the shaft until it clicks into place. Carefully press on the detent with a paperclip (or provided tool) while sliding the lever into place. – Note; The left side of the center shaft is the side that’s completely circular. Orientation (45/90 & up/down) of the lever isn’t important during this step, you can adjust it later in step 3.
2. Next install that selector-center bar assembly you made in step 1 from the left side of the receiver inwards. Use the small flathead from before to press the selector detent down while rotating the assembly inwards until it’s all the way through the right side of the receiver. – Note: The Selector detent sits inside the right side of the receiver under the trigger spring. The trickiest part is getting the center shaft over this selector detent. Having the hammer forward greatly assists installation during this step – Note: Once installed onto the selector detent; if the assembly is not at the desired 45 or 90 degree angle of throw, remove the safety assembly from the detent and rotate it 180 degrees, then reinstall.
3. Once the assembly is in the receiver at the desired 45/90 degree throw, install the right side lever with the spring and detent (just like in step 1). If needed; adjust the left lever orientation by removing the lever and re-installing it. To remove the lever: press the detent in the center of the selector lever and slide of of the center shaft. 4.Perform a trigger safety functions test – reinstall lower onto your firearm – Enjoy selectors!
Download the PDF Here!
