This is a REPLACEMENT Bridge insert for all Gen1 MREX rails. If a replacement Bridge is needed we recommend replacing the MREX Gen1 Hardware as well. This Bridge will not work in an MREX MkII.
Included:
- (1) Replacement Bridge
- (2) M5-0.80 x 10mm 90-degree flat head fastener
- (1) M5-0.80 x 8mm 90-degree flat head fastener
Installation:
- Insert Bridge into rail at slight angle.
- Align bottom and side holes.
- Apply a healthy amount of Red Loctite (or equivalent) to fasteners.
- Tighten to 40in/lb – Starting with the bottom 8mm fastener.
- Let adhesive cure before installing rail onto firearm.
MREX Gen1 Hardware Kit: MREX Replacement Hardware Kit – 1st Gen ONLY – Kinetic Development Group LLC (kineticdg.com)